Replacing a failed stack member – Cisco 2975 User Manual
Page 44
3-6
Catalyst 2975 Switch Hardware Installation Guide
OL-17784-01
Chapter 3 Troubleshooting
Replacing a Failed Stack Member
Replacing a Failed Stack Member
1.
Get a replacement switch that has the same model number as the failed switch.
2.
Power down the failed switch.
3.
Make sure that the replacement switch is off, and then connect it to the stack.
4.
Make the same connections on the replacement switch that were on the failed switch.
5.
Reinstall any modules, and make cable connections.
6.
Turn on the replacement switch.
The replacement switch has the same configuration for all the interfaces as the failed switch and
functions the same as the failed switch.
If you had manually set the member numbers for any members in the stack, you need to manually assign
the replacement switch with the same member number as the failed switch. See the switch software
configuration guide on Cisco.com.