KGUARD Security BR1621 - Manual (Page 18)

ENGLISH
Chapter 2: Installation
18
DVR User’s Manual
2.1.2 Installing HDD on 16-Channel DVR
The 16-channel DVR supports up to two 3.5” SATA hard disk drives. To install the HDD, follow the steps below.
5
Attach the bracket back to the compartment using
four (4) screws.
6
Connect the data cables to the hard disk drive (HDD).
7
Connect the power cables to the hard disk drive (HDD)
and the DVR.
8
Attach the cover and screws back in place.
1
Loosen the screws on the left, right, and rear sides as
shown.
2
Push back then lift up the cover to remove it.
3
Detach the screws to remove the HDD bracket.
4
Attach the HDD to the bracket using the four (4)
supplied screws.