KGUARD Security BR1621 - Manual (Page 88)

ENGLISH
Chapter 5: KGUARD Web Client
88
DVR User’s Manual
5.5.4 Setting the Network Configuration
You can use the Network menu to setup how the DVR connects to the network. It provides 3 network connection
options: Static IP, DHCP, and PPPoE.
Note:
Consult your network administrator or the Internet Service Provider (ISP) to determine the type of connection you are
using and the required parameters to complete the setup.
Network Settings
To configure the network settings, do the following:
1
On the Main Menu, click Remote Setting.
2
On the left panel, click Network > Network. The Network screen appears.
• DCHP: With Dynamic Host Configuration Protocol
(DHCP) service, your router will automatically assign
an IP address to your computer connected to the
network.
• PPPoE: The Point-to-Point Protocol over Ethernet
(PPPoE) is a network protocol for encapsulating
Point-to-Point Protocol (PPP) frames inside Ethernet
frames. This network protocol allows the device to
be directly connected using a DSL modem.
• Static IP: This network protocol allows you to
configure the network interface using a fixed IP
address.
3
Specify the Client Port and HTTP Port numbers.
• Client Port: Specify the port number that the device will use to send DVR command and video stream.
• HTTP Port: Specify the port number that you will use to log in to the device.
Note:
• Obtain these information from your network administrator or your Internet Service Provider (ISP).