Compaq AP500 - Manual (Page 112)

4-36 Diagnostic Tools
SCSI Test Error Codes Continued
Error Code Description Recommended Action
XXXX-30 Controller timed out. Replace the indicated device.
XXXX-31 Unrecoverable error Replace the indicated device.
XXXX-32 Controller/drive disconnected. Replace the indicated device.
XXXX-33 Illegal controller command Replace the indicated device.
XXXX-34 Invalid SCSI bus phase Replace the indicated device.
XXXX-35 Invalid SCSI bus phase Replace the indicated device.
XXXX-36 Invalid SCSI bus phase Replace the indicated device.
XXXX-39 Error status from drive Replace the indicated device.
XXXX-40 Target timed out. Replace the indicated device.
XXXX-41 SCSI bus stayed busy. Replace the indicated device.
XXXX-42 ACK/REQ lines bad. Replace the indicated device.
XXXX-43 ACK did not deassert. Replace the indicated device.
XXXX-44 Parity error Replace the indicated device.
XXXX-50 Data pins bad. Replace the indicated device.
XXXX-51 Data line 7 bad. Replace the indicated device.
XXXX-52 MSG, C/D, and/or I/O lines bad. Replace the indicated device.
XXXX-53 BSY never went busy. Replace the indicated device.
XXXX-54 BSY stayed busy. Replace the indicated device.
XXXX-60 Controller CONFIG-1 register bad. Replace the indicated device.
XXXX-61 Controller CONFIG-2 register bad. Replace the indicated device.
XXXX-65 Media not unloaded. Replace the indicated device.
XXXX-90 Fan failure 1. Verify fan(s) connections.
2. Replace nonfunctional fan(s).
XXXX-91 Over Temperature 1. Ensure proper air flow.
2. Perform required maintenance and cleaning.
XXXX-99 Autoloader reported tapes not loaded properly. 1. Install tape(s) in autoloader tape drive
according to test instructions.
2. Change autoloader magazine.