Compaq AP500 - Manual (Page 98)

4-22 Diagnostic Tools
Computer Setup Features Continued
Task Computer Setup Selection
Set the printer mode (flexible/standard). Click Built-in Devices, then click Communications. Under
Parallel Port, select the appropriate Bi-directional Port.
Set the Num Lock state at power-on. Click Built-in Devices, then click Input Devices. Under
Keyboard, turn on Num Lock State At Power-on.
Disable energy saver mode. Click Built-in Devices, then click Power Management. Select
Energy Saver Disabled.
Select timeout values.
NOTE: These selections appear only the when energy
saver mode is set (default).
Click Built-in Devices, then click Power Management. Under
Hard Drive and/or Monitor, select the Timeout value.
Enable/disable power LED blink in suspend mode
NOTE: This selection does not appear if the energy saver
mode is disabled.
Click Built-in Devices, then click Power Management. Select
Blink LED during Energy Saver.
Enable the Power-On Password. Click Built-in Devices, then click Security Management.
Under Power-On Password, click Set.
Enable/disable keyboard QuickLock, QuickBlank screen
when locked, and QuickLock in energy saver mode.
NOTE: These selections appear only if a Power-On
Password is set.
Click Built-in Devices, then click Security Management.
Under Power-On Password, select the appropriate options.
Enable the Setup (administrator) Password. Click Built-in Devices, then click Security Management.
Under Setup Password, select Enable Setup Password.
View current settings of Plug and Play (PnP) devices and
set resources for installed boards.
Click Integrated and Add-in Devices, then click ISA Boards.
View the currently installed PCI devices and view and/or
reconfigure settings (IRQ, I/O, DMA, memory).
Click Integrated and Add-in Devices, then click PCI Boards.
Enable/disable the SCSI controller boot order for Compaq
SCSI options.
Click Integrated and Add-in Devices, then click PCI Boards.
Under SCSI Controller Boot Order, select Enable Boot Order.
Enable/disable PCI bus mastering, PCI VGA palette
snooping, and interrupt sharing.
Click Integrated and Add-in Devices, then click PCI Boards.
Under System Options, select the appropriate options.
Restore factory default settings and exit Computer Setup. Select File, then select Set Defaults and Exit.
Exit Computer Setup without applying or saving any
changes.
Select File, then select Exit Without Saving Changes.
Save changes to the system configuration and exit
Computer Setup.
Select File, then select Save Changes and Exit.