Longshine LCS-844MT - Manual (Page 42)

38
set idle - (time in seconds) – set automatic logout.
when the program or communication is idle
set xfer -
the command is for RS-232 configuration
and data communication setting. The
command syntax is as below.
set xfer [arg_1 data_1] [arg_2 data_2] ...
[arg_n data_n]
[Argument List]
Port........... Set TCP port number
statistics..... Clear statistics
upgrade - Use this command to upgrade the firmware.
i.e upgrade firmware xxx.xxx.xxx.xxx Soft2.bin
set snmp - Use this command to set SNMP settings
of the device server.
Web Browser Interface
Warning
After each configuration session, be sure to set DIP
switch 1 to the ‘OFF’ position. Otherwise, the device
server will not transmit any data.