Longshine LCS-WR5-3214N - Manual (Page 31)

General Wireless Advance Settings
Items Information
Some 802.11g wireless adapters support
802.11g protections, which allows the adapter
search for 802.11b/g singles only. Select “Auto”
to turns it on or off automatically, select
“Always On” to support protection or select
“Always Off” to disable this function.
BG Protection Mode
The transfer rate of data packets of this
wireless router. The wireless router will use the
highest possible selected transmission rate to
transmit the data packets. Three selections:
“1-2 Mbps”, “Default (1-2-5.5-11 Mbps)”, and
“All (1-2-5.5-11-12-24 Mbps).” Basic Data Rates
Beacons are packets sent by an access point
to synchronize a wireless network. Specify a
beacon interval value. Default (100ms) is
recommended. Beacon Interval
Data Beacon Rate
(DTIM) Enter a value between 1 and 255 (default 1) for
the Delivery Traffic Indication Message (DTIM).
A DTIM is a countdown informing clients of the
next window for listening to broadcast and
multicast messages.
This value should remain at its default setting
of 2346. If you experience a high packet error
rate, you may slightly increase your
fragmentation threshold within the value range
of 0 to 2346. Setting the fragmentation
threshold too low may result in poor
performance.
Fragment Threshold
Request To Send threshold. This value should
remain at its default setting of 2347. If you
encounter inconsistent data flow, only minor
modifications to the value range between 1
and 2347 are recommended. RTS Threshold
Transmit power. You can set the output power
of wireless radio. This value should remain at
its default setting of 100. If you Tx Power
The length of CRC block in the frames during
the wireless communication. Short Preamble
Indicates that the 802.11g network is using a
short slot time because there are no legacy
(802.11b) stations present Short Slot
Select to enable or disable connecting to a Tx
Burst supported device. Tx Burst
To aggregate lots of packets into a big one
before transmitting packets. This can reduce
control packet overhead. Package Aggregate
* Please click on the Save Settings button or the Reset Settings button on the above table
to save/reset the configurations.
November 10, 2008 / Version: 2.0 26