Canon 430 - Manual (Page 140)

138
Image is blurred or
out of focus The subject is hard
to focus on • Use the focus lock or AF lock to
shoot.
See Shooting Hard-to-Focus Subjects
(Focus Lock, AF Lock) (p. 72).
Subject in recorded
image is too dark Insufficient light for
shooting • Set the flash to on.
Subject is dark in
contrast to the
background • Set the exposure compensation
to a positive (+) setting or use the
spot metering function.
Subject is too far
away for flash to
reach • Shoot within 3.5 m (11 ft.) of the
subject at the maximum wide
angle or 2.0 m (6.6 ft.) of the
subject at the telephoto end
setting using the flash.
• Raise the ISO sensitivity and then
shoot. See Adjusting the ISO
Speed (p. 85).
Subject in recorded
image is too bright Subject is too close,
making the flash too
strong • When using the flash, stay at
least 46 cm (1.5 ft.) from the
subject.
Subject is bright in
contrast to the
background • Set the exposure compensation
to a negative (-) setting or use the
spot metering function.
Light is shining
directly on the
subject or reflected
off the subject into
the camera • Change the shooting angle.
Flash is set to on • Set the flash to off.
A bar of light (red,
purple) appears on
the LCD monitor Subject is too bright • This is a normal occurrence in
devices containing CCDs and
does not constitute a
malfunction. (This bar of light will
not be recorded when shooting
still photos, but it will be recorded
when shooting movies.)
Problem Cause Solution