New England Arbors VA20200 - Manual (Page 2)

S T E P S
2
Remove the two screws holding the solar keystone lid to the body
using a phillips head screwdriver and retain them to be used again
later on.
Connect the battery pack on the underside of the solar keystone lid
as shown.
Remove the existing keystone lid (only) on the desired keystone.
Use a flat-head screw driver to gently pry the lid off the keystone
body as shown.
Align and slide the solar light keystone lid and body to the existing
keystone as shown. The new keystone lid should lock into place.
Support the keystone body while fastening the two screws removed
in step 1.
The Solar Light Keystone Arbor
1
3
2
www.edenarbors.com
3
4
4
1
2
5
5
Note: if this is a new arbor installation,
don’t install the keystone top lid and
proceed to step 4