New England Arbors VA68101 - Manual (Page 3)

3
The Dublin Arbor
www.edenarbors.com
6
7
8
9
6 7 8
Lay out the side panel bottom horizontal rail and insert the middle
STRAIGHT vertical spindle (slightly shorter than outer vertical
spindles that will be bent into place).
Insert the two vertical spindles (slightly longer than middle vertical
spindle) that will be bent into place.
Slide the Side Panel Middle Horizontal Rail over the three vertical
spindles to about the middle of the vertical spindles.
Position the Side Panel Top Horizontal Rail and Insert the middle
vertical spindle.
Tension bend into place the two outer vertical spindles. The
assembled side panel will need to be held together until it is
inserted into the post.
Lay out one LEFT post (as identified) horizontally with holes facing
up and insert the assembled side panel by aligning the horizontal
rails with the holes on the post.
Lay out one RIGHT post (as identified) horizontally with holes
facing up and insert the assembled side panel and post into.
Fasten the side panel to the posts by using 1 1/4 in. (3.17cm.) screws
into the posts as illustrated. Ensure that all horizontal rails on side
panel “bottom out” inside the posts prior to screwing together.
Repeat as necessary for other side panel.
1
2
S T E P T W O
Assemble the Side Panels
3
4
5
1 2 3
4 5