New England Arbors VA84046 - Manual (Page 13)

Fastening Vinyl Beams, Rafters & Caps
13 12 x 12 Flat Top Pergola
1 Using 5/8” self-auguring stainless steel screws attach the pergola
rafters to the rafter brackets.
Install decorative pergola end caps using vinyl weld.
Install the post caps using vinyl weld.
Final position your post trims.
1
2
3
S T E P S E V E N
4
3
To position post trim in place:
1. Slide the post trim down.
2. Apply a generous amount of vinyl glue around the post
3. Slide the post trim back up to the desired location and
allow a few minutes for glue to cure.
4
2
To glue pergola end in place:
1. Apply a generous amount of vinyl glue to the pergola end as shown.
2. Slide the pergola end into the beam/rafter and allow a few minutes
for glue to cure.