NORAC UC4.5-BC Operator Manual - Manual (Page 34)

30
ACTIVE ROLL SYSTEM:
• Perform the Quick Install for the standard system as previously described.
• Navigate to the "Roll ?" menu prompt in the SETUP ( ) menu. Press and then change
it to "Roll OnA" using the buttons. Press to confirm.
• Navigate to the "Roll ?" menu prompt in the SENSOR DISPLAY menu. Select the
appropriate sensor serial number for the BF (boom frame) and IF (intermediate frame)
sensor. Press
, and then set the "IFh" (intermediate frame height) and "BFh" (boom frame
height) to zero using the buttons. Press to confirm.
• Perform a ReTune (Section 8.2).
BFh 0
IFh 0
Roll OnA