Carrier Access Network Device Axxius 800 - Manual (Page 194)

5-94 Axxius 800 - Release 2.2
CLI Commands
set
set lsprotect nonrevertive
Use the set lsprotect nonrevertive command to set low speed protected port(s) to non-revertive
mode.
When a port is in non-revertive mode and a failure occurs the port is switched to the protection
port, and will remain there until manually reset. However, if the port becomes healthy again and
another port has a failure the first port will revert, and the second port will then be protected.
Syntax: set lsprotect {slot:port} nonrevertive [priority]
[1-7]
Example: set lsprotect 5:1 nonrevertive priority 2
{slot:port}
The {slot:port} address of the protected port to be configured.
[priority]
An optional parameter, which defines the port priority in the event that multiple protection
requests are received for the same port number on different cards.
[1|2|3|4|5|6|7]
A parameter set with low speed priority, which sets the value of the port priority. Range is
1-7, default is 7. Priority 1 is the highest priority, 7 is the lowest priority.
slot Slot number (1-8) where a Quad T1 card is located
port Port number or range (1-4)