Carrier Access Network Device Axxius 800 - Manual (Page 238)

5-138 Axxius 800 - Release 2.2
CLI Commands
set
set (router) syslog level
Use the set (router) syslog level command to set the Syslog severity level. Events of all
severity levels lower in number (more severe) will be sent to the Syslog server.
Syntax: set {rtr_card-addr} syslog level {severity}
Example: set 3 syslog level 4
The example will set the Syslog severity level to 4, on the Router card in
slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{severity}
The severity threshold level can range from 0 to 7.
set (router) syslog server
Use the set (router) syslog server command to set the IP address of an external Syslog
server.
Syntax: set {rtr_card-addr} syslog server {ip-addr}
Example: set 3 syslog server 10.0.0.1
The example will set the external Syslog server IP address to 10.0.0.1, on the
Router card in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{ip-addr}
Set the IP address for the external Syslog server, using the form xxx.xxx.xxx.xxx, where
xxx is a number from 0 to 255.