Carrier Access Network Device Axxius 800 - Manual (Page 207)

Axxius 800 - Release 2.2 5-107
CLI Commands
set
set (router) dhcp server startaddr
Use the set (router) dhcp server startaddr command to enable the DHCP server on the
specified Router card.
Syntax: set {rtr_card-addr} dhcp server startaddr
{ip-addr} {count}
Example: set 4 dhcp server startaddr 134.200.3.1 254
The example will set the TSR in slot 4 to enable the DHCP server with 254
address pool starting at 134.200.3.1.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{ip-addr}
The starting address of the client address pool, in the form of xxx.xxx.xxx.xxx, where xxx
is between 0-255.
{count}
The number of IP addresses in the client address pool (1-254).