phil&teds vibe 2 - Manual (Page 14)

c Make sure the front wheel is in swivel
mode and the child harness is undone.
d Push the main seat base
(fabric seat) upward until it’s
fully inverted.
e Ensuring that the parcel tray is folded
upwards at the centre, depress the red
safety latch and fold
the frame together.
Folding
without double kit attached,
or with the double kit on front of the
buggy in toddler/newborn position.
Note The double kit must be attached to
the top set of holes if you wish to leave it
on while folding the buggy, see image
b .
Note If you would like to tow the buggy
like a trolley once folded, leave the brake
off and the bumper bar attached. (Super
useful in airports and the like!)
a Rotate the multi-adjust
handle into the highest
position.
b Open both of the black hinge locks.
(Those paddle things on either
side of the frame).
vibe folding instructions
model GT issue April 2008
Please read ALL the instructions and look CAREFULLY at the pictures. Trust us; this will really help!!!
Note When fully folded the front wheel
should rest on the buggy handle with the
Jbar facing outwards. (The Jbar is the black
plastic bit, shaped like an upside down ‘J’,
connected to the front wheel axle).
f Lay the buggy on the ground with the
handle facing upwards and close both
of the black hinge locks, (those same
paddle things).
done!
Jbar.
Here it is. Top holes.
Push the seat
fabric up from
underneath.