phil&teds vibe 2 - Manual (Page 8)

english pull bar
g slot pull bar into upper set of sockets
on centre front of buggy frame.
to remove: rotate bayonet release levers
‘1’ upwards, slide pull bar up frame, lift and
remove pull bar.
h when double kit is attached to front of buggy
(baby & toddler position), remove pull bar
and store in moulded sockets on rear
cross bar, as shown.
sunhood
i your vibe will arrive with its sunhood
attached, to remove: place thumbs on plastic
clips and rotate snap attachments outwards,
remove sunhood from frame.
to re-attach: lay sunhood on frame facing
down towards front end of buggy. use
palms of hands to snap attach plastic clips
onto frame. rotate sunhood backwards.
slide snap attachments up/down frame
to alter headroom.
intelligent handle adjustment
j to alter handle height: depress both black
buttons located on inside of handle and
rotate handle into desired position.
intelligent handle brake
k press small red button for park.
press large black button for go.
harness adjustment
l under padded seat, turn harness strap
retainer to vertical position and slide to either
top, middle, or lower setting. lock in place by
turning strap retainer to horizontal position.
note breastplate should fit snugly on baby’s
chest, allowing you to fit 2 average sized
fingers between straps and baby. harness
strap tension can be adjusted using clips
located at shoulder height.
ups ` downs
m vibe seat can be adjusted to any ergonomic
position from upright through to lie-flat.
n to adjust seat for recline: release seat
adjustment clip on seat back, recline seat into
desired position, secure seat adjustment clip.
to adjust seat for lie-flat position:
recline seat fully and undo zips on either
side of front seat pad.
double buggy
to use baby ` toddler position requires
purchase of phil`teds double kit accessory.
o double kit on back: fit double kit into
moulded plastic sockets on rear cross bar
and ensure bayonet fitting is secure. tilt
double kit back ensuring spring locks are
engaged. load heavier toddler in front seat
first. then place lighter toddler in double kit
3