phil&teds vibe 2 - Manual (Page 7)

inline
TM
buggy
vibe instructions
assembling your new phil`teds inline
TM
vibe
is effortless and tool-free. just follow these
simple steps and in 4.25 minutes you’ll be off.
bits ` bobs
the red numbers below refer to buggy parts
indicated inside the back flap of this guide.
1. intelligent handle brake
2. intelligent handle
3. wrist strap
4. double kit (sold separately)
5. fold lock
6. double kit harness
7. rear guards
8. rear axles
9. rear wheels
10. sunhood
11. back flap
12. slide lock harness
13. pull bar
14. red safety lock
15. footwell
16. swivel lock
17. double kit spring lock
18. front wheel
safe ` sound
we’ve attained the following safety standards.
• EN 1888:2005 • AS/NZS 2088:2000
• ASTM F833-07a
wheeling ` dealing
keep tyres inflated to 22PSI max
a attach rear guards by sliding them down
track at base of wheel frame. to remove rear
guards, pull bottom edge of guard outwards
and slide it up and out of track.
b insert axles into rear wheels (from side
without brake disk).
c to attach rear wheels: depress silver axle hub
and insert wheel axle into buggy axle housing.
d to unfold frame: open fold lock handles.
e open and extend buggy, close fold lock handles.
f to attach front wheel: fully extend swivel
lock knob and insert wheel rod into buggy
frame, as shown. release swivel lock knob
and check wheel is in place for use.
to place front wheel in swivel position: rotate
90 0 until swivel lock knob clicks into place
(visibly extended).
to lock swivel wheel: rotate 90
0 until swivel
lock knob clicks into place and is no longer
extended.
2