phil&teds vibe 2 - Manual (Page 9)

inline
TM
buggy
at back. always unload rear toddler first.
warning: never place a child in double kit
without a child in front seat.
p to remove: double kit from rear rotate
bayonet release levers upwards, slide double
kit backwards, lift and remove.
q attaching double kit to front: place vibe
seat in lie-flat position. remove pull bar from
front of vibe and fit double kit into front
frame sockets.
note double kit can fit in either set of sockets.
to remove from front of buggy: rotate bayonet
release levers
upwards, slide double kit
up frame, lift and remove.
note: double kit has a recline feature.
to activate: undo zips that run around back
of seat.
folding
to prepare for folding: rotate handle into
upper most position and ensure front wheel
is in swivel mode. release child harness.
release fold locks.
note vibe can be folded with double kit
attached to front or rear.
r folding without double kit on: depress red
safety lock.
s fold so that buggy nose cone and handle
come together, ensure front wheel lies flat
against buggy. lock frame and secure by
closing fold locks.
note: sunhood, pull bar, and double kit
can remain attached.
t folding with double kit on: release double
kit spring locks as shown.
note do not take double kit out of
moulded sockets.
u tilt double kit towards front of buggy.
lift front seat up and slide double kit
underneath. close fold/safety locks.
v folded buggy can be manoeuvred using
pull bar as handle.
add ` adapt
other products available for vibe:
buggy covers
•
single and double storm cover
• single and double mesh cover
buggy beds and liners
•
buggy cocoon
• snuggle & snooze sleeping bag
buggy storage
•
up & away travel bag
• base bag
• diddie bag
4