phil&teds vibe 2 - Manual (Page 15)

f Ensuring that the parcel tray is folded
upwards at the centre, depress the red
safety latch and fold the frame together.
Note When fully folded the front wheel
should rest on the buggy handle with the
Jbar facing outwards. (The Jbar is the black
plastic bit, shaped like an upside down ‘J’,
connected to the front wheel axle).
g Lay the buggy on the ground with the
handle facing upwards and close both
of the black hinge locks, (those same
paddle things).
done!
d Open the double kit nib springs, allowing
the double kit to pivot on the cross bar.
e Push the main seat base (fabric seat)
upward until it’s fully inverted. Push the
double kit forward into the
inverted seat base.
Push the seat
fabric up from
underneath.
These things are
the nib springs...
...and that’s the
cross bar. It’s still here!
Folding
with the double kit in rear
position
Note If you would like to tow the buggy
like a trolley once folded, leave the brake
off and the bumper bar attached. (Super
useful in airports and the like!)
a Rotate the multi-adjust
handle into the highest
position.
b Open both of the black hinge locks.
(Those paddle things on either
side of the frame).
c Make sure the front wheel is in swivel
mode and the child harness is undone.
Top holes.