phil&teds traveller (pre-2013) - Manual (Page 5)

english getting started
Letters in red refer to line drawings on the
inside front cover.
a Place the top of the traveller (large zipped
mesh) face down on the ground with the
four legs folded inwards on top of the
fabric.
b Take two of the silver half rails (no.3) &
snap them together to make one long
rail. Repeat for the second set of rails.
c Slide each long rail into the fabric
sleeves, one on each long side of the
traveller.
d Attach the two shorter ‘end’ rails to
the long ‘side’ rails using the plastic
connectors.
e Zip closed the retaining flaps at the short
ends of the traveller.
f Attach the legs to their corresponding
plastic corners. Ensure all four are secure
before moving on.
g Attach the red rubber foot tabs on the
underside of each foot to the hook on the
underside of the foot. Repeat for all four
feet. Then turn the traveller on to its feet.
h Locate the zip pull toggles and elastic
loops at both ends of the traveller. Feed
the toggle behind the aluminium leg &
through the elastic loop; securing it to
the side panel. Repeat at the other end
of the traveller.
i Remove the mattress from its packaging
3
& open the valve. The mattress will
automatically start to expand. When it’s
fully expanded secure the valve shut.
j To comply with the EN safety standard in
the UK: Unzip the double skinned floor,
insert the mattress between the two skins,
then close the zip. Secure the zip by
feeding the toggle behind the leg & through
the elastic loop on the side panel.
Rest of world: choose either the method
above, or place the mattress inside the
traveller itself.
NOTE: When the side access panel is not in use,
secure it closed using the toggle & elastic loop
at the base of the panel.
WARNING Never use the traveller without the
supplied mattress.
DO NOT use in conjunction with any mattress
other than the one supplied.
DO NOT blow into mattress to inflate. Moisture
inside the mattress reduces the ability for it to
inflate.
IMPORTANT: When outdoors anchor the cot to
the ground by placing the supplied pegs through
the holes in the feet.
packing up
k Unfasten all the toggles from the elastic
loops and remove the mattress from the
traveller. Undo the valve and compress by
rolling up.
l Turn the traveller upside down and release
the four red rubber foot tabs from each foot.