Charging warnings, Battery charger, Miss geico 24 – Pro Boat PRB0500 User Manual

Page 4: Instructions

Advertising
background image

Miss Geico 24

Charging Warnings

WARNING: Failure to exercise caution while

using this product and comply with the following

warnings could result in product malfunction,

electrical issues, excessive heat, FIRE, and

ultimately injury and property damage.

• Read all safety precautions and literature prior to use

of this product.

• Never leave the battery and charger unattended

during use.

• Never allow children under 14 years of age to charge

battery packs.

• Never attempt to charge damaged batteries.
• Never charge a battery if the cable has been pinched

or shorted.

• Never allow the batteries or charger to come into

contact with moisture at any time.

• Never charge batteries in extremely hot or cold places

(recommended between 50–80°F (10–26°C)) or in

direct sunlight.

• Always use only Ni-MH rechargeable batteries. This

charger cannot charge batteries such as “heavy duty",

“alkaline battery”, “mercury battery”, or

“lithium battery”.

• Always connect to the charger correctly.
• Always disconnect the battery and charger after

charging and let them cool between charges.

• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon

Hobby if the product malfunctions.

• Always make sure you know the specifications of

the battery to be charged or discharged to ensure

it meets the requirements of this charger.

• Always connect the charge cable to the charger

first, then connect the battery to avoid short circuit

between the charge leads. Reverse the sequence

when disconnecting.

• Always constantly monitor the temperature

of the battery pack while charging.

• Always end the charging process if the charger

or battery becomes hot to the touch or starts

to change form during the charge process.

Battery Charger

This light and compact charger (DYN4113) quickly and

easily charges 5–8 cell Ni-MH battery packs with an

installed EC3

power connector.

Instructions

1. Connect the AC power cord to the power slot on

the charger, then connect the other end of the

power cord to an AC power source.

2. The Power LED and Charging LED will turn

GREEN when the charger is connected to

the AC power source.

3. Connect the battery pack connector to the

charge connector.

4. Press the On/Off button to charge the battery.

The Charging LED turns RED.

5. When the battery pack is fully charged, the Charging

LED will turn GREEN.

6. Press the On/Off button to stop charging. Disconnect

the battery pack connector from the charge connector.

CAUTION: If at any time during the charge

process the battery pack becomes hot to the

touch, unplug the battery immediately

and discontinue the charge process.

4

EN

Advertising