Section 11: stopping the engine, Section 12: initial launch of the miss llumar – Pro Boat PRB2550 User Manual

Page 12

Advertising
background image

12

With the transmitter antenna up, maneuver the Miss
LLumar in an oval, turning only to the right at slow
to medium speeds. Make certain that the boat and
radio system are functioning correctly.

As you are running the Miss LLumar in an oval,
watch for water being discharged from the water
outlet on the left side of the hull. Water flowing
from the water outlet indicates the engine is
being properly cooled. If you do not notice any
water coming from the water outlet, bring the
boat in and make sure that the water cooling line
or the brass water pickup located near the rudder
are not clogged.

If at anytime you notice the boat and/or radio
system are not functioning correctly, end the
operation of the boat immediately and do not run
the boat again until you are confident the problems
have been corrected.

Idle the boat near shore and press the kill switch
located on top of the cockpit as shown.

Section 12: Initial Launch of the Miss LLumar

Section 11: Stopping the Engine

Advertising