Pro Boat PRB2550 User Manual
Page 16
16
Simply follow the instructions below to properly
lubricate your drive shaft.
1. Carefully note how the entire drive shaft is
installed. This is pivotal in order to properly
re-assemble the drive shaft after you have
finished lubricating it.
2. Loosen and remove the two 2.0mm set
screws that secure the propeller shaft to the
brass ferrule. Remove the prop drive dog and
nylon washer.
3. Remove the drive shaft flex cable. Replace the
Teflon liner as needed.
4. Lubricate the entire flex cable with
waterproof grease as shown and then re-install
the flex cable back through the liner and stuffing
box and into the clutch.
5. Reassembly in reverse order. Make sure that
the set screws are tightened down on the flat
spots of the prop shaft. Also be certain to place
a drop of threadlock on each set screw before
re-tightening them.
Section 17: Maintenance (cont)