Pro Boat PRB3100 User Manual
Page 12
1
The Pro Boat ESC comes pre-wired with a Tamiya-
style connector compatible with most battery packs.
Use a 6- to 7-cell battery pack.
1. Make sure the On/Off switch is in the
"OFF" position.
2. Connect a fully charged battery pack to the
speed control’s battery connector.
Note: Refer to the radio
instructions for specific information
on transmitter setup.
It may be necessary to adjust the throttle trim knob
to stop the propeller from turning while the throttle
trigger is in the neutral position.
Adjust the rudder trim knob so that the
rudder is centered prior to operation. You
may adjust this control to make the boat run
straight during operation.
Throttle Trim
Steering Trim
Section 6: Connecting the Battery to the ESC
Section 7: Adjusting the Transmitter