Pro Boat PRB3100 User Manual
Page 14
1
1. Loosen the 1.5mm setscrew connecting the
drive shaft to the motor coupler.
2. Loosen the 1.5mm setscrew connecting the
universal joint to the drive shaft.
3. Remove the two 3mm screws from the
outdrive to separate the rudder assembly from
the mount. Make sure not to lose the 3mm nuts
when removing the screws.
4. Move the rudder assembly and slide the drive
shaft out of the stuffing box.
5. Lubricate the drive shaft with drive shaft with
water-proof grease (see your local hobby shop).
Reinstall the drive shaft in reverse order. Be
sure to reinstall the nylon washer between the
universal and the stuffing box.
Note: Running the ShockWave 26
EP RTR in salt water could cause
some parts to corrode. If you
run the boat in salt water, rinse it
thoroughly in fresh water after each
use and lubricate the drive system.
Section 10: Lubricating the Drive Shaft
Apply Lubricant