Pro Boat PRB3100 - Manual (Page 13)

1
The ESC in your ShockWave 26 RS is pre-
programmed from the factory. The following has
been provided if you happen to need to reset the
programming of your ESC.
1. Turn on the transmitter’s power switch. Be sure
the transmitter batteries are fully charged.
2. Place the boat in position to allow the propeller
to move freely or disconnect one of the motor
wires from the motor.
3. Turn on the receiver switch. Move the throttle
trigger (stick) to full throttle, then to full
reverse. The ESC will automatically memorize
the initial movement of the throttle channel each
time the receiver switch is turned on.
4. To reset the maximum throttle setting, simply
turn the ESC's power switch off then on and
move the throttle stick to full movements again.
5. When operation is complete, turn off the
receiver, then the transmitter.
Note: Do not turn off the
transmitter first or the receiver
may pick up stray signals and run
out of control.
Before and at the end of each run, make sure
all screws are tight and the propeller is free from
any entanglement.
Section 8: Speed Control Programming
Section 9: Maintenance