Rev-A-Shelf 4WB-1723-52 - Manual

Installation
Instructions
We hope you enjoy your new wood accessories from
Rev-A-Shelf. We pride ourselves in providing the best quality, service
and innovation in the industry. If you have any questions about our
products, feel free to call our Customer Service Specialist at
800-626-1126
2409 Plantside Drive
Jeffersontown, KY 40299
502-499-5835 • FAX: 502-491-2215
www.rev-a-shelf.com
I-WOOD 11-05
STEP 1:
Using a table saw cut
width of insert to fit
inside of drawer.
STEP 2:
Cut back of insert off
to fit from inside front
to rear of the drawer.
STEP 3:
Place inside drawer.
Cutlery/Spice/Utility Tray Insert
STEP 1:
Measure width between
center of door frame rails.
STEP 2:
Transfer this measurement to rack and tighten
adjustable mounting brackets.
STEP 3:
Mark hole locations and fasten to door
.
Sink Base Door Storage
STEP 1:
Measure
width
between
center of
door frame
rails.
STEP 2:
Transfer this measurement to
rack and tighten adjustable
mounting brackets.
STEP 3:
Mark hole locations
and fasten to door.
Note:
4SR requires 4 1 / 2
" of
clearance behind door.
Existing shelves must
be modified to allow
space for these bins.
DM Spice Rack 4SR-15, 4SR-18, 4SR-21
STEP 1:
See accompanying insert.
Adjustable Spice Rack 4ASR-15,
4ASR-18, 4ASR-21
Note:
4ASR requires 4 1 / 2
" of
clearance behind door.
Existing shelves must be
modified to allow for
these bins.
4 1 /
2
"
4 1 /
2
"
Hook that holds the
trays to the standards.
Two on each tray already
attached to the back.
STEP 1:
Measure width
between center of
door frame rails.
STEP 2:
Transfer this meas-
urement to rack and
tighten adjustable
mounting brackets.
STEP 3:
Mark hole locations and fasten to door.
DM Cutting Board 4DMCB-15, 4DMCB-18
STEP 1:
See accompanying insert.
Uses Full-Extension Ball-Bearing Slides.
Drawer Cutting Board/Knife Rest
4KCB-18, 21, 24
Pivot-Out Spice Rack 4PSR-18, 4PSR-21
Note:
Includes magnetic latch.
Install if needed.
STEP 1:
Remove or adjust any existing
interior shelving
STEP 2:
Attach hinge to spice rack.
STEP 3:
Attach hinge to cabinet frame
opposite side from door hinges.
Adjustable Mounting Brackets
DOOR
x
DOOR
x
DOOR
x