Rev-A-Shelf LD-4NW-0436-1 - Manual

INSTALLATION INSTRUCTIONS
REQUIRED WHEN MOUNTING FULL ROUND 6070 UPPER PANTRY SHELF
SYSTEM DIRECTLY ABOVE 6060 SERIES LOWER PANTRY SHELF SYSTEM
1. Using template provided, drill four (4) each 7/32" diameter holes through the mounting
panel.
2. Use four (4) each 10-32 by 1" oval head self-tapping screws to fasten mounting flange
to the positioner assembly.
3. Locate screw holes with template provided and install lower mounting flange for the
Lower Pantry Shelf System with four (4) each 3/4" by 8 oval head screws.*
4. Proceed with steps 2-5 of the installation instructions for the 6060 series Lower Pantry
Shelf System.
5. Locate screw holes with template provided and install upper pivot support for the Upper
Pantry Shelf System with four (4) each 1/2" by 8 truss head screws.
6. Proceed with steps 3-5 of the installation instructions for the 6070 series Upper Pantry
Shelf System
* Mounting flanges are tapped for jack screw accessory. If used, drill 1" diameter hole through
bottom floor only.
I 2-598 rev 08/06
12400 Earl Jones Way Louisville, KY 40299
(800) 626-1126 • rev-a-shelf.com