SeaLand DFP flush switches - Manual (Page 6)

6
4 VacuFlush Toilet Operation with
VFS or VFP Flush Switch
4.1 Toilet system start-up
1. Turn on electrical power and water supply to toilet.
2. Flush water through entire toilet system by flushing toilet five
times (press “Flush” switch and allow each flush cycle to
complete until green light indicates system is ready for next
flush). Each cycle takes about one minute.
4.2 Normal toilet operation
ADD WATER TO TOILET BOWL (and panel backlighting function)
Press “Add Water” switch until desired water level is achieved. More water is usually
added only when flushing solids. (If switch is pressed too long, water flow will shut
off automatically to avoid overflow.)
BACKLIGHTING: To turn switch backlighting effect off or on, push “Add Water”
switch twice very quickly.
FLUSH TOILET
Press “Flush” switch down for a moment, then release it. Flush only when the green
“OK to Flush” light is on. Toilet will not flush until the green “OK to Flush” light is on.
It takes about one minute for vacuum to recharge for the next flush.
If the red “Do Not Flush” light is on, the system is either recharging the vacuum, or
the holding tank is full. Do not attempt to flush the toilet during these conditions, or a
clog may occur in the toilet system.
DO NOT FLUSH FOREIGN OBJECTS
CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue paper. Do not
flush wet wipes, sanitary napkins, condoms, diapers, razor blades paper cups,
cotton swabs food, hair or liquids such as oils or solvents. Clogging or damage to
the toilet system may occur.
Note
Make sure all guests understand toilet operation before use.
4.3 Changing flush modes
SeaLand VacuFlush all-ceramic toilets offer two flush settings to help manage water consumption:
Normal flush – Uses 1 quart (0.95 liter) per flush. Adds water to bowl after every flush.
Dry Bowl flush – Uses 1 pint (0.5 liter) per flush. Does not add water to bowl after flush.
To change from Normal to Dry Bowl flush setting, press “Flush” switch for about five seconds. When
green “OK to Flush” light on status panel begins flashing, release “Flush” switch. Flush mode has
been changed to Dry Bowl setting. Change mode to Normal flush by following the same procedure.
4.4 Indicator lights
“OK TO FLUSH” INDICATOR
A steady green “OK to Flush” light indicates when the toilet is ready to flush. A
momentary flashing green light indicates when flush mode is changing.
(continued on next page)