SeaLand 3400 Series All-Ceramic Toilets - Manual (Page 7)

7
ModeL 3400 ReMoTe fLuSh SWITch INSTALLATIoN
3400 series toilets feature a remote flush switch to control the “Flush” and “Add Water” functions. Follow
the instructions below for switch installation.
STEP : Select a location for the switch. 8 feet of cable (2.4 m) is provided. You may need to supply more wire,
depending on how far you locate the switch from the
toilet.
STEP 2: Cut an opening 1-1/4” wide x 1-5/8” high (see
diagram at right).
STEP 3: If installing the switch in a shallow wall, you
may need to use the spacer between the wall and the
switch assembly cover to allow space for the wire con-
nectors. If so, route the cable through the spacer before
proceeding to the next step.
STEP 4: Route the 3-conductor cable through wall
cut-out and on to toilet. Cable can be routed with water
supply line and power wires (see page 5, Step 9). Leave
a minimum of 30 inches (.76m) of cable to allow easy
wiring at toilet.
STEP 5: Fasten the switch assembly to the wall with
the #6x1” screws (included), making sure to install with
the label “THIS SIDE UP” on top. Otherwise, the “Flush”
and “Add Water” functions will be reversed.
STEP 6: Snap cover onto switch assembly to complete
switch installation on wall.
STEP 7:
WITh The eLecTRIcAL PoWeR off,
connect the red, black and white wires from the switch
to the red, black and white wires connected to the ,
2 and 3 terminals on the control module. See page
6, Step 7 for other wiring procedure.
1-5/8 inch
(4 mm)
Cover
outline
Spacer
outline
ReMoTe fLuSh SWITch coMPoNeNTS
-/4 inch (32 mm)