Shellab SSI10R-2 - Manual (Page 4)

SHEL LAB SI9/SI9R Shaking Incubator Operational Manual
4
Copyright © 2007 Sheldon Manufacturing. All rights reserved.
All specifications and features for this product are subject to change without notice.
U U s s i i n n g g t t h h e e U U n n i i t t S S a a f f e e l l y y
Introduction
Thank you for choosing a SHEL LAB shaking orbital incubator. SHEL LAB sets the standard for quality and reliability.
Your unit is backed by over 30 years of design and manufacturing excellence in the scientific, research, and medical
equipment industries.
Your unit is a general-purpose incubator designed for professional, industrial or educational use where
 
the preparation or testing of materials is done at approximately atmospheric pressure, and
 
no flammable, volatile or combustible materials are being heated.
These units are not intended for use at hazardous or household locations.
Before you use the unit, read this entire manual carefully to understand how to install, operate, and maintain the unit in a
safe manner. Your satisfaction with the unit will be maximized as you read about its safety and operational features. Keep
this manual on-hand so it can be used by all operators of the unit. Be sure all operators of the unit are given appropriate
training before you put the unit in service.
Use the unit only in the way described in this manual. Failure to follow the guidelines and instructions in this
manual may be dangerous and/or illegal.
General Safety Considerations
Your incubator and its recommended accessories have been designed and tested to meet strict safety requirements.
For continued safe operation of your incubator, always follow basic safety precautions including:
 Read this entire manual before using the incubator.

Be sure you follow any city, county, or other ordinances in your area regarding the use of this unit.
 Use only approved accessories. Do not modify system components. Any alterations or modifications to your
incubator may be dangerous and will void your warranty.
 Always plug the unit’s power cord into a grounded electrical outlet that conforms to national and local electrical
codes. If the unit is not grounded, parts such as knobs and controls may conduct electricity and cause serious injury.
Do not connect the unit to a power source of any other voltage or frequency beyond the range stated on the power
rating overlay at the rear of the unit.

Do not modify the power cord provided with the unit. If the plug does not fit an outlet, have a proper outlet installed
by a qualified electrician.

Avoid damaging the power cord. Do not bend it excessively, step on it or place heavy objects on it. A damaged cord
can easily become a shock or fire hazard. Never use a power cord after it has become damaged.
Precautions for Your Unit
Observe the following additional safety guidelines for your unit.

Operating Conditions For optimum performance use your incubator at room temperatures between 18 and 25

C, at
no greater than 80% relative humidity. If you intend to operate the unit in conditions outside of these limits, contact
customer service.

Installing the Unit Installation of the unit can be performed by the end user

Lifting and Handling The incubator is very heavy and should be moved by a lifting device, such as pallet jack. If you
must lift the device by hand, always observe the following guidelines:
o Do not move the incubator while it is plugged into the power source.
o Remove all moving parts, such as shelves and trays, before you move the unit. Make sure the door is securely
shut.
o Use at least four people to lift the incubator.
o Lift the unit from its bottom surface only.
o Do not use doors, handles or knobs to lift or stabilize the unit.
o Keep the unit from tipping.
 Servicing Your Unit Only qualified personnel should service your unit. Faulty service may be dangerous and will
invalidate the unit’s warranty. Do not operate the unit if any parts are damaged or missing.
 Maintenance Unplug the unit from its power source before attempting any maintenance.