Capresso Impressa S7 - Manual (Page 20)

When the actual brewing starts the display alternates the
following messages:
ENOUGH COFFEE? and PRESS KEY P .
• When the desired amount of coffee is in your cup, press the
P button. The machine stops brewing and the display shows:
–_ _ _ ll_ _ _+
At this time you have two options:
Option 1: Press the P button. The machine will save the cup
size you just programmed and the display will show
WATER QUANTITY / PRESS KEY You can now program the
cup size for another coffee button.
Option 2: If you press the + or – buttons you can now increase
or decrease the amount of water slightly. The vertical bars in the
display will move to the right or left. Put a cup underneath the
coffee spout. Now press the coffee button again. The machine
will repeat the process.
• Press the N button to return to
COFFEE READY or press the
+ button to go to the next function.
15.4 PROGRAMMING STEAM PORTION
If you want the same amount of frothed milk you can program
how long the frother should dispense steam. The advantage is
that the frothing will stop automatically. This is particularly
useful when using the frothXpress Plus system. At the time of
programming, the machine will not froth. It will simply store the
time (3 to 250 seconds).
COFFEE READY
• Press the P button.
POWDER QUANTITY / PRESS KEY
• Press the + button until the display shows
STEAM PORTION
• Press the P button.
PORTION /....20 SEC.
• Press the + or – button to change the frothing/steaming time.
• To store this new setting in memory press the P button.
STEAM PORTION
• Press the N button to return to COFFEE READY or press the
+ button to go to the next function.
15.5 PROGRAMMING HOT WATER ( TEA PORTION )
You can program the hot water spout to deliver between 1 ⁄
2
oz.
and 16 oz. of hot water.
COFFEE READY
• Press the P button.
POWDER QUANTITY / PRESS KEY
• Press the + button until the display shows
TEA PORTION
• Place a cup under the hot water spout (Fig.8a or 8b).
• Press the P button.
OPEN TAP
• Turn the selector switch to the water symbol (Fig.3,L). Hot
water will flow into your cup. The display shows
ENOUGH TEA? / CLOSE TAP
• When you have enough hot water in your cup turn the
selector switch back to the cup symbol (Fig. 3,L). The hot water
flow will stop.
TEA PORTION
• Press the N button to return to COFFEE READY or press the
+ button to go to the next function.
15.6 PROGRAMMING THE CLARIS CARTRIDGE
See chapter 11b.
20.