Capresso Impressa S7 - Manual (Page 25)

the tray for approx. 20 seconds and then replace it.
• Place a large container (24 oz.) underneath the
coffee spout (Fig.1, 1).
ADD TABLET/ PRESS CLEANING
• Open the ground coffee funnel lid (Fig.1,10) and drop one
white tablet into the opening (Fig.23).
• Push the TABLET CLEANING button (Fig.3A,S) again.
• The machine will start the automatic cleaning program by
dispensing water in intervals into the container underneath
the coffee spout.
• When finished, the display shows EMPTY TRAY and the
machine "beeps".
• Remove the tray. There will be water in the tray and in the
used coffee container. Empty, clean and replace.
RINSE UNIT
• Place a cup underneath the coffee spout and push the
RINSE button (Fig.2,F).
COFFEE READY
• Clean the ground coffee funnel after each cleaning cycle.
• Remove the funnel and rinse under hot water and dry.
• Replace funnel (Fig.21 and 22).
17.2 DECALCIFYING
The machine has an integrated decalcifying program. When the
shows
UNIT CALCED it is time to decalcify the machine. You
can still make coffee. However, it is highly recommended that
you decalcify the machine within the next 2 days.
Note: If you use the Claris water cartridge and the message
UNIT CALCED is displayed, then your cartridge function is not
activated. Follow the instructions in chapter 11a.
Run the decalcifying program only after the machine has been
switched off for at least 5 hours and has cooled down
completely. IMPORTANT: The decalcifying program must not
be interrupted.
DECALCIFYING AGENT:
Only use our special decalcifying tablets. For supplies see
chapter 19.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
Decalcifying Procedure
UNIT CALC
• Remove, empty water tank and replace
• Turn off machine and let it cool down for approx. 5 hours.
• Open cover (3), push and hold the DECALC button
(Fig. 3a,T1) until you hear a "beep".
EMPTY TRAY
ATTENTION: Even if the drawer is empty you must remove it
for at least 20 seconds. Replace drawer.
AGENT IN TANK
• Remove Water Container. Fill with 20 oz. of water and
completely dissolve the contents of one blister pack (2
tablets).
AGENT IN TANK / OPEN TAP / PRESS CALC
• Make sure that the frothing attachment is removed and place
a large container under the steam nozzle (Fig. 4).
25.