Sterling Scale 820 - Manual (Page 8)

DW800/820 Operation Manual
Counting Operation
The Counting Operation cannot be accessed, if the NTEP parameter is set to True
(see parameter setup) or the Units of Weight parameter is set to LB/KG, LB/G, KG/G, or ALL.
The Count Operation is started by pressing and holding the UNIT key. The indicator will toggle
thru all allowable sample sizes, starting with the current sample size. When the desired
sample size is displayed release the UNIT key. The indicator will sample the pieces and
display the count.
Count Key Operation: During counting operations the key are used as follows:
OPERATION
PAGE 6
_____________________________________________________________________________________________________________
Revision 4.3 Copyright ©2004 Sterling Scale Co., Inc. May 2004
Web Site: www.sterlingscale.com E-mail: [email protected]
The ZERO key is used to zero the scale.
The TARE key is used to tare the weight on the scale. Place the
empty container on the scale and then press the TARE key. The
display will indicate the new weight.
The PRINT key is used to print a weight ticket.
The GROSS/NET key is used to change the displayed weight from
Gross Wt. (tare + net = gross) to the Net Wt. (gross – tare = net).
The UNITS key is used to switch count and weigh operation. If held
down the count display will show the average piece weight.