Cisco WES610N - Manual (Page 17)

16
Advanced Configuration Linksys WES610N/WET610N
Bridge Information
Firmware Version The bridge’s current firmware is displayed
Local Network
Local MAC Address The bridge’s MAC Address, as seen on your local, Ethernet
network, is displayed
IP Address The bridge’s IP Address, as seen on your local, Ethernet network,
is displayed
Subnet Mask The Subnet Mask configured for your local network is displayed
Status > Wireless
Information about your wireless network is displayed
Wireless
Link Status The status of the connection to your wireless network is displayed
MAC Address The bridge’s MAC Address, as seen on your local, wireless
network, is displayed
Network Name (SSID) The wireless network name or SSID is displayed
BSSID The wireless MAC address of the connected wireless router (or access
point) is displayed
Radio Band The radio band of your wireless network is displayed
Channel Width The channel width, in MHz, used by your wireless network is
displayed
Wide Channel Depending on the channel settings of your network router,
the Wide Channel is displayed If you selected Wide - 40MHz Channel for the
router’s Radio Band or Channel Width setting, then this will be your primary
Wireless-N channel
Standard Channel The Standard Channel setting is displayed If you selected
Wide – 40MHz Channel for the router’s Radio Band or Channel Width setting,
then the Standard Channel will be a secondary channel for Wireless-N
Bit Rate The data transmission rate is displayed
Signal The percentage of signal strength is displayed 100% is the strongest
signal strength possible; 0% is the weakest possible
Security The security method of your wireless network is displayed