Encode, Encode menus/values – TeeJet LH665 VRT User Manual
Page 36
A
PPLICATION CONTROL
,
ENCODE
&
CALIBRATION
LH 665 VRT O
PERATORS MANUAL
4.2
LH A
GRO
ENCODE
The necessary values for application control are encoded in the following menus.
ENCODE MENUS/VALUES
All encodements are selected as follows (presupposes APPLICATION
CONTROL is selected under Operating Mode as described on page 3.3):
Step
Key
Procedure
1
Press the MENU key until the following menu selection keys
are displayed at the bottom of the screen (screen section C):
CAL
SETUP
DIAG
2
SETUP
Press the SETUP key.
3
Page through the available encode menus using the lower
ARROW keys:
APP RATE
CONFIG
CARD
LOAD
MARKS
CONSOLE
GPS
MAP
MEMORY
When encoding a numerical value simply pressing the arrow keys will move the
cursor to the next digit, e.g. if a value of 12.4 is to be encoded, use the left arrow
key to select the first digit (1) arrow up until 1 is displayed. Now move the cursor to
the right using the right arrow key and encode the value 2, move the cursor to the
right again.