Toa C-CC774 PL - Manual (Page 68)

68
Z O O M S C A L A B L E P / T
M A X P / T S P E E D
P / T L I M I T S E T T I N G
* M A N U A L *
P / T L I M I T
F L I P
U P L I M I T
1 2 0
A U T O
O N
O F F
L E F T
O N
Manual setting screen
11.5. Setting the Flip Function (C-CC564, C-CC574, C-CC764 and C-CC774 only)
Sets a tilt operation (rotating the camera vertically) between –90° to –185°. (Factory default : OFF)
OFF: Turns the Flip function off.
Tilt operation between –90° to –185° cannot be performed.
AUTO: Turns the Flip function on.
This function flips the image shown on the monitor when the camera stops executing a tilt
operation (rotating the camera vertically) between –90° to –185°.
MECHANICAL: Turns the Mechanical Flip function on.
This function flips the image shown on the monitor by rotating the camera 180° in the panning
direction while its tilt operation (rotating the camera vertically) is going on at the range of
–90°.
Notes
• If Backlight Compensation is set to “WIDE DYNAMIC”,
backlight compensation by “WIDE DYNAMIC” will not
function for the duration that the Auto-Flip function is in
operation.
• The Auto-Flip function automatically switches to OFF
when the Privacy Masking function is ON ( p. 77 ) or
Rotation Limit function is ON.
• When the Auto-Flip function is in the process of flipping
the image on the monitor, the Slow Shutter function
(
p. 36 ) will not operate.
• When setting Preset Memory for the C-CC564, C-
CC574, C-CC764 or C-CC774, it is recommended that
the Auto-Flip function be turned off temporarily.
1. On the Manual Setting screen, select “FLIP” with the joystick,
then press the Set key.
The arrow
moves to “OFF” (factory default).
2. Select “AUTO,” “OFF,” or “MECHANICAL” with the joystick,
then press the Set key.
The Auto-Flip function is then set.
( )
-185°
-90°
5°
Lens
Range of
Auto Flip operation