USL JSD-100 Manual User Manual

Page 11

Advertising
background image

 

11 

 

Analog Audio Outputs – Accessibility  
 Hearing Impaired – User selectable input channel or LCR mix.  300mV mono balanced. 
 Visual Narration – User selectable input channel (8 or 16).  300 mV mono balanced.   

 

Eight Channel Analog Audio Output (JSD‐100x) 
 Eight Channels Balanced 300mV adjustable (L, C, R, Ls, Rs, LFE, Lc/Lrs, Rc/Rrs). 
 
Sixteen Channel Analog Audio Output (JSD‐100xA) 
 Sixteen Channels Balanced 300mV adjustable.  Configurable as 5.1, 7.1 broadband, biamp three or five screen 

channels, triamp three screen channels or 13.1 

 

Thirty‐two Channel AES Output (JSD‐100xD) 
 Thirty‐two audio channels on 16 AES pairs. Configurable as 5.1, 7.1, or 13.1 broadband, biamp or triamp five 

screen channels. 

 
Communication Ports 
 DB25F pulse automation. 
 Serial control – RS‐232. 
 USB for laptop setup. 
 Ethernet 10/100 ‐ RJ45. 
 
Front Panel Interface
 
 Eleven buttons:  COAX1, COAX2, TOSLINK, DIGITAL 16 CH, USER 1, USER 2, ANALOG 8 CH, NON/SYNC, AUX, 

MIC, and MUTE. 

 Main Fader – 0‐10 used for main audio and bypass audio. 
 Front panel displays fader level and selected format. Bar graphs display output levels. 
 USB connector. 
 Power switch and power supply status LEDs.  Turning power off activates bypass mode. 
 
Format Selection 
 Digital (COAX1, COAX2, TOSLINK, 8 to 16 Channel AES‐EBU). 
 Analog (8 channel, Non‐Sync, Auxiliary, Microphone). 
 User 1, User 2 (Configurable in software, e.g., digital 16 channel at lower level, 7.1, 13.1, etc.). 
 
Rear Panel Connectors – Main Chassis 
 PA Microphone – XLR / ¼” phone jack.    
 Calibration Microphone – 3.5mm stereo jack. 
 Eight Channel Analog – DB25F. 
 Non/Sync – two RCA jacks. 
 AUX – two RCA jacks. 
 Hearing Impaired and Visual Narration – pluggable Phoenix connector. 
 COAX1 and COAX2 – RCA Jacks with transformer input 
 TOSLINK – Optical. 
 16 Channel Digital AES‐EBU – DB25 and Dual RJ45. 
 Removable Memory Card – SD compatible. 
 Serial Control – RS‐232 on DE9F. 
 Pulse Automation – DB25F. 
 10/100M Ethernet – RJ45. 
 DC 12V Power Connector – 5mm with 2.5mm pin. 
 AC Power – IEC socket.  100‐240VAC, 50/60Hz, 18W typical, 7.5W sleep. 
 

Advertising