USL JSD-100 Manual User Manual
Page 41
41
Full Range
Audio Channel
Biamp Audio
Channel
Triamp Audio
Channel
Phoenix Main Output Pins
(+, ‐, shield)
DB25M Monitor 1 Output
Pins (+, ‐, shield)
Left
Left Low
Left Low
1, 2, 3
2, 14, 1
Center
Center Low
Center Low
4, 5, 3
5, 17, 4
Right
Right Low
Right Low
6, 7, 8
8, 20, 7
LFE
LFE1
LFE1
9, 10, 8
25, 12, 13
Ls
Ls
Ls
11, 12, 13
23, 10, 22
Rs
Rs
Rs
14, 15, 13
24, 11, 9
Lrs/Lc (Lc only
in 13.1)
Lc Low
Lc Low
16, 17, 18
16, 3, 15
Rrs/Rc (Rc only
in 13.1)
Rc Low
Rc Low
19, 20, 18
19, 6, 18
Full Range
Audio Channel
Biamp Audio
Channel
Triamp Audio
Channel
Phoenix Optional Output
Pins (+, ‐, shield)
DB25M Monitor 2 Output Pins
(+, ‐, shield)
LFE2
Left High
Left High
1, 2, 3
2, 14, 1
OUT 9
Lc High
Left Mid
4, 5, 3
16, 3, 15
OUT 13
Unused
Center Mid
6, 7, 8
25, 12, 13
OUT 14
Center High
Center High
9, 10, 8
5, 17, 4
OUT 10
Rc High
Right Mid
11, 12, 13
19, 6, 18
LFE3
Right High
Right High
14, 15, 13
8, 20, 7
Lrs
Lrs
Lrs
16, 17, 18
23, 10, 22
Rrs
Rrs
Rrs
19, 20, 18
24, 11, 9
AES Output Module
AES output modules are available with up to 32 output channels (16 AES pairs) on four RJ45 connectors. The first
two connectors (identified as CH 1‐8 and CH 9‐16) are used for full range 5.1, 7.1DS, and 7.1SDDS speaker
configurations. These two connectors also handle biamp and triamp 5.1 and 7.1DS. The last two RJ45 outputs are
used for additional speaker configurations. The tables below identify which audio channels are available on which
AES pair of which RJ45 connector. In the tables below, cable pairs are identified by CableNumber‐PairNumber.
Cable 1 plugs into the jack identified as CH 1‐8. Cable 4 plugs into the jack marked CH 25‐32. Note that not every
cable is used in every configuration. The cable pairs go to the connector pins identified in the table below.
Cable Pair
RJ‐45 Pins ( +, ‐ )
1
1, 2
2
3, 6
3
4, 5
4
7, 8