Vexilar FL-10 - Manual (Page 23)

23
TB0032 - Dual Beam 9/19° puck transducer. for mounting
on a electric trolling motor, in-hull mounting, portable use,
or ice fishing. Comes with 25 feet of cable. Built-in switch
box must be mounted within 3 feet of the depth finder.
"S" CABLE - The S-Cable (short for
Suppression Cable) is used to reduce the
output power of the FL-10. This can often
help clear up readings in shallow or clut-
tered waters. If you are finding that the
FL-10’s gain control is set to minimum, but you still have
too much signal on the display, the S-Cable will help.
Simple installation between the unit and transducer.
SB-100 Switch Box - The SB-100 Switch Box allows you to
run two transducers on one FL-10 unit. You could switch
between a trolling motor mounted transducer and a stern
mounted one or, while ice fishing, switch between the hole
you are fishing from and a remote hole. Also, the SB-200 is
available as a switch box for two units and one transducer.
CB0001 10 Foot Extension Cable
CB0002 20 Foot Extension Cable
If the standard transducer cable is not long enough for
your application, you can get an extension. Cable length
can be extended up to 50 feet without any significant per-
formance degradation.