Vexilar FL-10 - Manual (Page 5)

panel. Ideally you want the outside nut to be as close to the
outer end of the shaft as possible. When the right spacing has
been achieved tighten snugly into place.
Make sure the inner shaft portion is rotated fully
counter-clockwise and then place the larger rubber o-ring fol-
lowed by the larger control knob onto the shaft. Using the
provided wrench, tighten the knob down. Make sure that the
white mark lines up with the OFF position on the decal. Next
install small rubber o-ring and then the smaller control knob.
Make sure that, with the shaft turned fully counter-clock-
wise, the white mark lines up with the minimum position.
Finally, plug the eight pin connector from the flasher unit into
the back of the control and tighten snugly.
Connect the power cable to a 12 volt source. It is
recommended to use the main starting battery for power.
Connect the white wire to positive and the black to negative.
5
Figure 4