Vexilar Edge 3 - Manual (Page 14)

14
MENU 4
The forth and final menu contains controls for some basic func-
tions and unit of measure settings.
SUPER RANGE
Super Range controls the way the display appears when the
depth range changes. When Super Range is OFF, and the range
changes, you will see the point at which the range changed on the
display. This point will scroll across the screen until it disappears
at the far left side. When Super Range is ON, there will be no
visible point at which the depth changed. Super Range adjusts
the entire display to the new range.
To activate or disable the Super Range feature press...
MENU --> MENU --> MENU --> MENU (HOLD)
then or .
PULSE-LENGTH
Pulse Length controls how long each “ping” of the transducer is.
Longer pulse lengths allow better deep water performance but
reduce resolution. Shorter pulse lengths give the best resolution,
but have problems reaching into deep water.
To change the Pulse Length press...
MENU --> MENU --> MENU --> MENU (HOLD)
then and then or .
STC
STC stands for Surface Time Control. Its function is to reduce the
surface clutter normally found in the first few feet of the water
column by reducing the gain in this region.
To activate or disable STC press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> and then or .
DEPTH
The Depth feature controls how the digital depth number appears
at the bottom of the display. Your choices are OFF, S (Small), or
L (Large). OFF turns off the digital depth and all other digital
indications. Small displays the digital depth and other indicators.
Large makes the digital depth appear larger and easier to read.
The other indicators stay the same size.
To change the Depth setting press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> --> and then or .
DEPTH-UNIT
This feature lets you choose between Meters and Feet for depth
measurement.
To change the Depth-Unit setting press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> --> -->
and then or .
TEMP-UNIT
This feature lets you choose between Celsius and Fahrenheit.
To change the Depth-Unit setting press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> --> -->
and then or .