Vexilar Edge 3 - Manual (Page 15)

15
TEMP-ADJ
This feature allows you to calibrate the temperature reading, if
necessary.
To modify the temperature reading press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> -->
and then or .
VOLT-ADJ
This feature allows you to calibrate the voltage reading, if neces-
sary.
To modify the temperature reading press...
MENU --> MENU --> MENU --> MENU (HOLD)
then -->
and then or .
SYSTEM-RESET
System Reset will revert all settings back to the factory originals.
This can be handy for trouble shooting erratic operation or simply
getting the setting back to a known state.
To perform a System Reset press...
MENU --> MENU --> MENU --> MENU (HOLD)
then --> --> .
System Reset will cause the lose of all modified settings.
ACCESSORIES & REPLACEMENT PARTS
Depth
TBX071
107 kHz Transducer $79.00
TBX072 400 kHz Transducer $79.00
CB0001 10’ Transducer Extension Cable $24.00
CB0002 20’ Transducer Extension Cable $29.00
HSB003 Transducer Transom Bracket $5.00
TBH001 Transducer Transom Housing $3.00
BKT003 One-Piece Transducer ETM Bracket $18.00
ACE001 A.C.E. Transducer Adhesive $8.00
Temperature
TPX002
Temperature Probe $39.00
CB0003 10’ Temp Probe Extension Cable $35.00
Mounting
GBX003 Unit Gimbal Bracket $20.00
GKX003 Gimbal Bracket Knob $2.30
PCX002 Power Cord with Fuse $16.00
Switch Boxes
SB-100* Switch Box - 2 transducers on 1 unit $45.00
SB-200* Switch Box - 2 units on 1 transducer $45.00
*You need one switch box for each beam.
Prices subject to change without notice