Winco Mfg. Room Chair 5580 - Manual (Page 2)

Page 2 of 8
006325 Rev. I Date 06-27-13 JWC
5. Use (1) one of the Clevis Pins and insert it FROM the inside of Back Frame Fork, THROUGH hole in Seat
Frame and, THROUGH outside of Back Frame Fork.
REPEAT FOR OPPOSITE SIDE OF CHAIR.
(FIG.2)
6. Insert (2) Bow Tie Cotter Pins, into the small holes on ends of the (2) Clevis Pins you just installed. (FIG.1)
7. Remove the Bow Tie Cotter Pin and the Clevis Pin from the Back Support Strut (attached to back frame).
8. Align the holes of the Back Support Strut with the holes in the Angle Brackets and insert the Clevis Pin into
these aligned holes and secure with the Bow Tie Cotter Pin.
Operation of the Chair:
1. NON-RESTRAINT (5570 only): To make the chair permanently non-restraint, unbolt the Position Lock Bar
from the back of the chair.
2. The 5570, 5580, & 5670 recliners have three (3) positions; UPRIGHT, SEMI-RECLINE, and RECLINE, which
can be achieved by user or attendant. 5570 Only: The position lock bar can only be engaged or disengaged
by attendant. Not all notches on Position Lock Bar are used for this model chair.
3. POSITION LOCK (5570 only): Attendant may hold the chair in a reclined position by engaging the Position
Lock. To safely accomplish this, recline the chair to the 2
nd
or 3
rd
recline position and lower the position lock
with your hand until the notches on the Position Lock bars engage with the Position Lock Pins.
To release Position Lock, raise the Position Lock off of the Pins and return chair to upright position.
4. This chair is equipped with (4) Twin-wheel locking casters.
Twin-wheel locking casters (3" BLACK casters only) will lock wheel but will NOT prevent wheel from
swiveling. To lock, push down on the wheel tab.
NOTE:
All 3" BLACK casters are wheel locking ONLY. They DO NOT have a TOTAL and DIRECTIONAL lock feature.
To ensure proper operation of the reclining mechanism, lubricate all pivot points with a silicone type lubricant (or lubricant
approved by your facility) at least twice yearly. Periodically recheck tightness of all screws and bolts.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal. Please allow 1-2
weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original appearance
WARNING: Attendant must release Position Lock before patient can exit chair – If patient attempts
to exit chair with Position Lock engaged, SERIOUS INJURY MAY RESULT.
WARNING: Failure to release the Position Lock before changing positions will result in damage to
the chair and void the warranty.
Periodically recheck tightness of all screws and bolts, and never use the chair arms, backrest, legrest or
tray as a seat.
FIG.1
FIG.2
Back Support
Strut
Angled
Bracket
Seat
Frame
Back Frame
Forks