Winco Mfg. Room Chair 5580 - Manual (Page 3)

Page 3 of 8
006325 Rev. I Date 06-27-13 JWC
Swing-arm Operation: (For Model: 5680 only)
1. To open, push the red latch handle to unlock the
swing-arm. (FIG. 3A)
2. To close, push swing-arm toward latch until latch
engages. (FIG. 3)
Operating Instructions for Table OPTIONS available for your recliner:
*Side-Table (LT, RT, DT)
To position side-tables
1. To raise table, grasp center of table and gently raise into place.
Table will automatically lock into place when released. (FIG.4)
2. To lower table, grasp table at the center, raise and pivot down in
one movement.
*Pivot Table (NP, PN)
“Lap Position”
1. To place pivot-table in “lap” position, pivot the table away
from chair and pull over lap. (FIG.5)
2. Tighten star-knob to secure the pivot-table in the lap position
“Exit” Position
1. With the table in the “lap” position, loosen star-knob & push
table away to exit chair.
Remove Pivot-Table
1. Loosen pivot-table star knob.
2. Pull up on pivot-table until the table stem comes out of the
black bracket.
Other available Options:
IV Pole
IV
Contoured Headrest
CH00
Torso Support
TS00
Side Cushion
SC00
FIG.4
FIG.5
FIG.3
A