Wingscapes BirdCam Pro - Manual (Page 12)

Camera Setup
Battery lnstallation
Make sure the Power switch is in the OFF position. Open the camera cover. Press the Battery
Chamber Release button. Install 6 C-Cell Alkaline batteries. Make sure that the (+ and -)
polarities match the polarities indicated inside the battery chamber holder. Reinsert the
Battery Chamber into the camera until you hear an audible click.
Note: Anytime you load or unload batteries, make sure that the camera is OFF.
Warning: If using 12V DC Camera Power Adapter, do not remove internal batteries.
DO NOT use lithium batteries.
Insert SD Card
Camera needs to be powered off when installing and
removing SD card. You will need to open the front cover
to insert an SD memory card. You can insert an SD Card
up to 32 GB. Insert the SD Card in the direction indicated
on the card, until you hear an audible click.
Note: Camera will not operate without an SD memory
card installed.
Power ON
Slide the Power Switch to the ON position. The display will show the current mode selected
by the Rotary Dial. Choose the mode by rotating the dial between the options (PLAYBACK,
SETUP, MOTION, TIMELAPSE, and MOTION+T.L.) to make changes to settings or operate the
camera in the different modes.
Page 12 BirdCam PRO User Guide