Zipper's Performance 109-214 - Manual (Page 2)

3. Unplug the throttle body harness and install
the arming switch over the rear cylinder head
throttle body support bracket using the original
breather bolt. Install supplied breather spacer to
the front head using the other original breather
bolt. Re-install throttle body harness with NADS
harness routed under T-Body harness plug.
4. Install supplied breather spacer chrome caps
onto the breather ‘S’ hoses and install the hoses
to the breather bolts.
5. Slide the chrome breather caps along the
breather hoses and push them into place on the
breather spacers/arming switch housing.
6. Position the NADS backing plate over the
throttle body; insert the breather hoses through
the two openings in the backing plate as shown.
7. Insert supplied gasket between backing plate
and throttle body. Apply blue threadlocker to
threads of (3) supplied air filter stanchions and
install. Tighten stanchions to 120-140 in/lbs.
8. Plug two-wire harness connector into NADS
solenoid attached to backing plate. Route
remaining harness up to frame backbone, under
fuel tank to ECM area under seat as shown.
9. Electrical Harness
Installation:
Remove
left side frame cover
and remove the ECM
fuse. Disconnect the
negative
battery
cable. Carefully
disconnect the wiring
harness
connector
from the ThunderMax.