Zipper's Performance 109-214 - Manual (Page 4)

12. Install the nitrous line to the solenoid fitting.
Route line down towards front tappet block,
forward of the front cylinder to the left frame
down tube.
13. Apply blue threadlocker to threads of (3)
supplied air filter element screws and install the
air filter element.
14. Locate the supplied A/C cover washer.
From inside the cover, place the supplied
washer over the cover bolt. Apply blue
threadlocker on the threads of the bolt and
install the cover assembly onto the air filter
element.
Bottle / Bracket / Line Kit Assembly
After filling bottle, install the nitrous bottle using
supplied model-specific brackets. The bottle
mounts with the outlet at the bottom. Install the
brackets to the left frame down tube; leave the
clamp screws slightly loose. Place the bottle in
the bracket cradle and install the clamps loosely.
Attach the nitrous line and orient the bottle so
that the hose is routed without interfering with
the shift linkage or any other component (clamp
provided for attachment to tappet cover screw).
Tighten all clamp screws securely.
Software Setup
You should always check to see if you are
running
the latest available version of
ThunderMax software and your module’s
firmware is up to date. Software and firmware
updates are available with a high-speed Internet
connection through your TMax software. Please
verify you have the latest version before you
proceed.
Open the TMAX software. Link to the module
and select [CONFIGURE], scroll down to
[MODULE Settings] [NITROUS] and the
following dialog page appears: