Ram Trucks 2015 ProMaster Commercial - Diesel Supplement User Manual
Page 58
MESSAGE
DESCRIPTION
Press Brake Pedal / Startup Delayed
This messages appears when the key is first turned ON, if the brake
pedal is not depressed and/or the shift lever is not in NEUTRAL (N).
The shift lever must be in the NEUTRAL (N) position, and the brake
pedal must be pressed, to allow engine cranking. Place the shift lever in
NEUTRAL (N) and apply the brake pedal BEFORE turning the key to
the START/AVV position; otherwise, the engine will not crank and the
key must be cycled OFF, then back on, before cranking is allowed.
Gear Unavailable
This message appears, along with a warning buzzer:
• When it is not possible to change gear due to a fault in the system.
• When, due a fault in the system, it is only possible to engage 1st
(1), 2nd (2), 3rd (3) or REVERSE (R).
Contact your authorized dealer if the message continues to appear.
Shift Not Allowed
This message may appear when starting the engine at low tempera-
ture. In this case the Automated Manual transmission isn’t able to
engage first gear, in this situation either use the engine block/
transmission heater or allow the engine to idle in NEUTRAL (N)
until the transmission has warmed.
56 STARTING AND OPERATING